Staghorn fern grow as epiphytes directly on living trees and on sway without grease in tropical climates . They can be successfully grown on wood or other types of mounts with only the little amount of organic matter . Mounting is well-fixed . If the fern ’s origin can quell in middleman with the mount long enough , it will eventually confiscate to it and no longer need to be connect down .

Step 1

Place the mount slab flat on a table with the front confront up and make up one’s mind which part will be the top . Use the wire to make a hook or loop topology at the top of the mount to hang it up when you are complete . For dull mounting materials like redwood or cypress , you may need to bore a pickle to fertilize the wire through . With softer materials like Sir Herbert Beerbohm Tree fern slabs , the telegram can be pushed through the fibers comparatively easily .

Step 2

Lay a small rounded hammock of wet sphagnum moss in the middle of the mount . The mound should be an inch fatheaded and wide enough to extend slightly beyond the diam of the sterile shield fronds at the base .

Step 3

take the staghorn fern from the greenhouse tidy sum it come in and carefully knock off the excess soil . Be trusted to leave a root mass .

Step 4

lay the solution mass on the mound of sphagnum moss so the fecund frond are oriented correctly when the backing is hanging from the conducting wire . The sterile frond should lay as bland as potential against the moss .

Step 5

bind a eyelet of fishing line around the climb and wrap it over the sterile frond . Continue to wrap up the line around the mountain and the plant until it is firm in place with the moss sandwiched between the mount and the bottom of the plant . Do not wrap too tightly because the air will cut through the leaves . Avoid damage the growing bud where the fat fronds egress .

Step 6

Tie off the production line and clip the spare line with the scissors .

Step 7

Soak the mount , sterile fronds and moss with a all right atomiser of weewee from the hose until completely saturated , then permit dribble ironical .

Step 8

cling the plant in a fly-by-night localisation for several weeks before moving it into brighter Inner Light in its concluding growing localization . The fishing job can be removed within a few month after several new shield frond develop , or it can be provide on and will finally be covered by leafage .

Tip

When selecting a mount , use a rot - repellent wood such as redwood or cypress , otherwise it will rot quick . you’re able to also utilize pottery , or even stone . Some people have had winner with plastic mounts . prefer a mount that will fit several years of growing . Some staghorn fern get very enceinte and may need to be remounted every few years . Any eccentric of wire or drawing string can be used in place of fishing line , as long as it is not copper and will reject decay for a couple of growing seasons . Some people choose to nail the sterile frond to the mount at once with galvanized nails or staples rather of sportfishing job .

Warning

Although the fern will attach directly to concrete such as wall , this is not advise because the etymon will cause the concrete to crack over time . Staghorn fern can also be mounted straightaway on a tree proboscis , but this is not advised because they will keep on moisture against the tree barque and potentially start the door for rot .

Things Needed

References

…

…